F 350 4WD Super Duty V10-6.8L VIN V (2005)
Control Module: Procedures
Four-Wheel Drive (4WD) Control Module
Removal and Installation
CAUTION: Prior to removal of the four-wheel drive (4WD) control module, it is necessary to upload module configuration information to a
diagnostic tool. This information needs to be downloaded into the new module once installed.
1. Disconnect the battery ground cable.
2. Open and lower the glove box compartment.
3. Disconnect the connectors from the 4WD module.
4. Remove two nuts, one bolt and the 4WD module.
5. To install, reverse the removal procedure.
