F 350 4WD Super Duty V10-6.8L VIN V (2005)
11. CAUTION: The urethane bead must have a triangular cross section.
Cut the applicator tip of Essex 400 HV Urethane High Viscosity Adhesive, Ford specification WSB-M2G316-B, to specification. This will
produce a triangular bead during application.
12. CAUTION: The windshield glass must be positioned within 10 minutes of applying the urethane adhesive.
Apply a uniform 11-mm (0.43-inch) bead of Essex 400 HV Urethane High Viscosity Adhesive, Ford specification WSB-M2G316-B, on top of
the existing trimmed urethane bead on the pinchweld.
-
Make sure that all gaps in the urethane bead are smoothed into one continuous bead.
13. WARNING: Inadequate or incorrect curing of the urethane adhesive will adversely affect windshield glass retention. After installing
urethane bonded glass, the vehicle must not be driven until the urethane has cured. Using Essex 400 HV at 21°C (70°F) and relative
humidity above 50%, adequate cure time is typically 24 hours (less at higher temperatures and higher humidity). Follow manufacturer's
instructions.
CAUTION:
-
Before positioning the windshield glass, open vehicle windows to prevent the air pressure of closing doors from affecting the adhesive
bond.
-
The windshield glass must be positioned within 10 minutes of applying the urethane adhesive.
Using the alignment marks made previously, position the windshield glass on the pinchweld.
14. Check the glass installation for air or water leaks.
15. Install the roof trim panel.
16. Install the inside visor.
18. Install the windshield side garnish mouldings.
19. Install the interior rear view mirror.
20. Install the cowl vent grille.
