F 350 4WD Super Duty V10-6.8L VIN Z Bi-Fuel (2001)
1. Install the power steering pump pulley.
-
Inspect the pulley for paint marks in the web area near the hub. If there are two paint marks, discard the pulley. If there is no paint or one paint
mark, use a paint pencil to mark the web area of the pulley near the hub.
-
Use the Power Steering Pump Pulley Replacer.
2. Install the drive belt.
Pulley - Pump CIII and Motorhome Chassis
Pulley - Pump CIII and Motorhome Chassis
Special Tools(s)
Special Tools(s)
Removal
1. Remove the drive belt.
2. Raise the vehicle.
3. Remove the pulley using the Steering Pump Pulley Remover.
Installation
CAUTION: Replacement of the power steering pump pulley is necessary after being removed and in stalled two times.