F 350 4WD Super Duty V10-6.8L VIN Z Bi-Fuel (2001)
20. Using the special tool, press the bearing cup into position.
21. CAUTION: The assembly requires centering to install the final bearing cup, due to spring pressure.
NOTE: Position the Jaws of the special tool into the driveshaft center yoke bearing cup bores.
With the special tools in position, hand-tighten the Differential Bearing Remover to center the spider trunion in the bore.
22. Using the special tool, install the final bearing cup.
^
Remove the special tools.
23. NOTE: If necessary, tap the yokes with a soft-faced hammer to seat the bearing cups.
Install the remaining snap rings.