F 350 4WD Super Duty V8-5.4L SOHC VIN L (1999)
Brake Rotor/Disc: Service and Repair
Brake Rotor/Disc
Front
Disc-F-250, F-350 4x4 and F450, F-550
Removal
CAUTION: When installing anew disc brake rotor, measure the hub flange to verify correct part installation. Early build vehicles have a 10 mm
thick flange; late build vehicles have a 13 mm thick flange. The disc brake rotors are not interchangeable between early and late build vehicles. If an
incorrect part is installed during the repair, symptoms such as brake drag, extensive lining wear. brake shudder and the associated brake noise may
occur.
1. Remove the front disc brake caliper anchor plate.
2. NOTE: Perform this step for F-250 and F-350 4x4 SRW vehicles.
Remove the rotor.
3. NOTE: Perform this step for DRW vehicles.
NOTE: If excessive force must be used during brake rotor removal, the brake rotors should be checked for lateral runout prior to installation.
Remove the eight hub extender nuts, the hub plate and the rotor.
1. Remove the eight hub plate nuts.
2. Remove the hub plate.
3. Remove the rotor.
Installation
