F 350 4WD Super Duty V8-6.0L DSL Turbo (2003)
2.
Locate the battery ground cable stud bolt at the right front corner of the engine block. See Figure 1. Grasp the ground cable assembly by hand and
determine if it is loose at the block.
3.
Remove the positive battery cable bracket from the stud bolt.
4.
Remove the ground cable stud bolt from the engine block and discard.
5.
Inspect for evidence of arcing or carbon buildup on the ground cable eyelet terminal. Clean as necessary.
6.
To ensure a good ground path, use a wire brush or equivalent to clean the engine block surface and ground cable mating surfaces.
7.
Install the new ground stud bolt. Tighten it to 62.5 Nm (46 lb-ft).
8.
Install the positive battery cable bracket to the stud bolt. Tighten it to 30 Nm (22 lb-ft).
9.
Grasp the ground cable assembly by hand and make sure it is tight at the engine connection.
10.
Lower the hoist.
NOTE:
The following steps are only required if the battery ground cable was found loose in Step 2.
11.
Open the hood and locate the radio suppression strap near the right rear corner of the engine compartment.
12.
Inspect the suppression strap for signs of heat damage from increased amperage flow due to the loose ground connection at the engine block.
^
If no damage is found, close the hood and release the vehicle.
^
If the suppression strap shows signs of heat damage, inspect the surrounding components for similar damage. Repair as necessary.