F 350 4WD Super Duty V8-7.3L DSL Turbo VIN F (2001)
7. Remove the crankshaft damper wear ring.
1. Assemble the step plate adapter, damper wear ring remover, bearing collet sleeve, remover tube and forcing screw to the crankshaft vibration
damper.
2. Tighten the forcing screw until the crankshaft damper wear ring is pulled free from the hub of the crankshaft vibration damper.
Installation
1. Thoroughly clean the crankshaft front seal mounting surface.
2. Coat the new crankshaft front seal with multi-purpose grease.
Note: If necessary, rotate the Front Crank Seal Replacer to align it with the crankshaft key.
Note: Install a new crankshaft damper wear ring whenever the crankshaft vibration damper is removed. Apply a coating of sealant on the inside surface
of the wear sleeve.