F 350 4WD Super Duty V8-7.3L DSL Turbo VIN F (2001)
INSTALLATION
1. Follow the removal procedure in reverse order.
NOTE: Install a new pushnut during installation.
Panel/Floor Door Vacuum Control Motor
REMOVAL
1. Release the stops and lower the glove compartment door.
2. Remove the panel/floor door.
1
Disconnect the vacuum line.
2
Remove the screws.
3
Rotate the panel floor door to disengage the lever and remove the panel/floor door.
CAUTION: Do not attempt to bend any part of the lever. It is brittle and will break.
INSTALLATION