F 350 4WD Super Duty V8-7.3L DSL Turbo VIN F (2001)
2.
Inspect the color of the CMP sensor and bracket assembly. See Figure 1 for location of the CMP sensor.
^
If the CMP sensor is gray with a silver bracket, no action is required.
^
If the CMP sensor is black with a gold bracket, proceed to the Service Procedure.
SERVICE PROCEDURE
NOTE:
There is currently no Ford approved Cam Position (CMP) Sensor pigtail available for service.
To avoid damage, please use caution when disconnecting/connecting the CMP connector.
In the event that you encounter a broken CMP Sensor connector, please contact the Special Service Support Center for repair
assistance/approval. Do not use any pigtail that is not approved by Ford Motor Company.
1.
Disconnect the wiring harness connector at the CMP sensor.
2.
Remove the retaining bolt and the CMP sensor and bracket assembly.
3.
Install a new CMP sensor and bracket assembly and retaining bolt. Tighten the retaining bolt to 24 Nm (18 lb-ft).
4.
Connect the wiring harness connector to the CMP sensor.