F 350 4WD Super Duty V8-7.3L DSL Turbo VIN F (2001)
1.
Disconnect the battery ground cable and wait at least one minute.
2.
Insert the ignition key and turn it to the RUN position.
3.
Insert a punch into the access hole (located in the lower steering column shroud, below the lock cylinder) and press the release button while
pulling out the ignition switch lock cylinder.
NOTE
SOME VEHICLES DO NOT HAVE AN ACCESS HOLE AND REQUIRE LOWER SHROUD REMOVAL. REFER TO THE APPROPRIATE
MODEL WORKSHOP MANUAL, IGNITION SWITCH LOCK CYLINDER REMOVAL AND INSTALLATION SECTION 211 IF
ADDITIONAL DETAIL IS REQUIRED.
4.
Install new Ignition Lock Cylinder and verify proper function.
Parts Block
OTHER APPLICABLE ARTICLES: NONE
SUPERSEDES: 02-19-4
WARRANTY STATUS: INFORMATION ONLY
Disclaimer