F 350 4WD Super Duty V8-7.3L DSL Turbo VIN F (2001)
5. CAUTION: Hold the slave cylinder over a suitable container.
Angle the slave cylinder so that the hydraulic tube connection port is above the push rod. Fill the slave cylinder with DOT 3 brake fluid
^
Use Ford High Performance DOT 3 Motor Vehicle Brake Fluid C6AZ-19542-AB or equivalent meeting Ford specification ESA-M6C25-A.
6. Remove the cap from the opening in the hydraulic tube. Position the new O-ring seal on the end of the hydraulic tube. Coat the O-ring seal with
DOT 3 Brake Fluid.
^
Use Ford High Performance DOT 3 Motor Vehicle Brake Fluid C6AZ-19542-AB or equivalent meeting Ford specification ESA-M6C25-A.
7. Connect and secure the hydraulic tube to the slave cylinder.
1
Connect the hydraulic tube to the slave cylinder.
2
Install the new roll pin.
8. Bench bleed the clutch hydraulic system.
9. CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, wash the surface with
water immediately.
Position the clutch hydraulic system in the vehicle.