F 350 4WD Super Duty V8-7.3L DSL Turbo VIN F (2001)
8. Clean grease deposits, dirt and rust from the following:
^
The driveshaft yoke areas.
^
All driveshaft components.
^
Wipe the bearing and rubber insulator of the driveshaft center bearing. Do not immerse in solvent.
9. Inspect the following:
^
The driveshaft slip yoke boot for rips or holes. Install a new boot if necessary.
^
The driveshaft center bearing support for wear or rough action. If roughness or wear as evident, install a new driveshaft center bearing support.
^
The center bearing rubber insulator for evidence of hardening, cracking or deterioration. Install a new insulator if necessary.
Installation
1. NOTE: Inspect the transmission, transfer case and axle seals for damage. Install new components as necessary.
NOTE: Lubricate the slip yoke spline with Premium Long-Life Grease XG-I-C or equivalent meeting Ford specification ESA-M1C75-B.