F 450 2WD Super Duty V10-6.8L VIN S (1999)
Information Bus: Testing and Inspection
Super Duty Series
1. Verify the customer concern.
2. Visually inspect for obvious signs of electrical damage:
VISUAL INSPECTION CHART
Electrical
^
Fuses
^
Damaged wiring harness
^
Loose or corroded connectors
^
Overhead Trip Computer (OTC)
^
Powertrain Control Module (PCM)
^
Electronic Crash Sensor (ECS) module
^
4-wheel anti-lock brake control module
^
Rear anti-lock brake control module
^
Auxiliary Powertrain Control Module (APCM)
^
Generic Electronic Module (GEM)
3. If the concern remains after the inspection connect the New Generation STAR (NGS) Tester to the Data Link Connector (DLC) located beneath
the instrument panel and select the vehicle to be tested from the NGS Tester menu. If the NGS Tester does not communicate with the vehicle:
^
check that the program card is properly installed.
^
check the connections to the vehicle.
^
check the ignition switch position.
If the NGS still does not communicate with the vehicle, go to Pinpoint Test J. See: Pinpoint Tests/Pinpoint Tests/J: No Communication - No
Power to the NGS
4. Go to Pinpoint Test PC. See: Pinpoint Tests/Pinpoint Test PC : Data Link Diagnostics Network Test
Module Configuration
1. Visually inspect for obvious signs of electrical damage. Refer to the following:
VISUAL INSPECTION
Electrical
-
Damaged wiring harness
-
Loose or corroded connectors
-
ABS Control Module
-
Generic Electronic Module or Central Timer Module (GEM/CTM)
-
Electronic Crash Sensor (ECS)
-
Overhead Trip Computer (OTC)
2. If the concern remains after inspection, connect the New Generation STAR (NGS) Tester to the Data Link Connector (DLC) located beneath the
instrument panel and select the vehicle to be tested from NGS Tester menu.
If NGS Tester does not communicate with the vehicle:
-
check that the program card is correctly installed.
-
check the connections to the vehicle.
-
check the ignition switch is in RUN position.
If the NGS Tester still will not communicate with the vehicle, refer to Information Bus (Multiplex Communication Network). See:
3. Refer to the Symptom Chart. See: Pinout Values and Diagnostic Parameters/Symptom Chart
Initial Inspection and Diagnostic Overview
1. Verify the customer concern.
2. Visually inspect for obvious signs of electrical damage:
VISUAL INSPECTION CHART
Electrical
^
Fuses
^
Damaged wiring harness
^
Loose or corroded connectors
^
Overhead Trip Computer (OTC)
^
Powertrain Control Module (PCM)