F 450 2WD Super Duty V10-6.8L VIN S (1999)
7. Remove the solenoid body assembly.
1
Remove the bolts.
2
Remove the nut.
3
Remove the solenoid body assembly.
8. Remove the solenoid screen assembly by rotating and pulling.
9. CAUTION: The steel electronic pressure control (EPC) check ball is spring-loaded under the valve body separator plate.
NOTE: If the valve body separator plates are not to be serviced, proceed to installation procedure.
Remove the valve body separator plate reinforcement.
1
Remove the bolts.
2
Remove the separator plate reinforcement.
10. Lower and remove the valve body separator plate and gaskets.