F 450 2WD Super Duty V10-6.8L VIN S (1999)
8. NOTE: The Gauge Block must be offset to obtain an accurate reading.
Rotate the Gauge Block several half-turns to ensure proper seating of the pinion bearings, and position the Gauge Block.
9. Install the Gauge Tube.
1
Position the Gauge Tube.
2
Install the differential side bearing caps.
3
Install the differential side bearing cap bolts.
10. NOTE: Drive pinion bearing adjustment shims, must be flat and clean.
NOTE: A slight drag should be felt for correct shim selection. Do not attempt to force the pinion shim between the Gauge Block and the Gauge
Tube. This will minimize selection of a pinion shim thicker than required, which results in a deep tooth contact in the final assembly of integral
rear axle assemblies.
Use a drive pinion bearing adjustment shim as a gauge for shim selection.
^
After the proper shim thickness has been determined, remove the Gauge Tube.