F 450 2WD Super Duty V10-6.8L VIN S (1999)
4. Remove the rear hub bolts and separate the rear hub from the rear disc brake rotor.
5. Remove the inner and outer bearing cups.
1
Using the Inner Bearing Cup Remover (Inner Hub Bearing Race Remover for Dana S135) and Driver Handle, remove the inner bearing cup.
2
Using the Outer Bearing Cup Remover (Outer Hub Bearing Race Remover for Dana S135) and Driver Handle, remove the outer bearing cup.
6. Clean the following components:
^
The spindle of the rear axle housing.
^
All the old grease and axle lubricant from the rear hub.
^
The rear wheel bearings and cups.
7. Inspect the bearing races and rollers for pitting, galling or erratic wear patterns. Check the rollers for end wear and replace as necessary.
1
A typical new bearing roller.
2
A worn bearing roller.
Installation