F 450 2WD Super Duty V10-6.8L VIN V (2005)
4. Pull the carpet or mat back to expose the rear body insulator bolt head.
5. Remove and discard the bolt.
6. Remove the insulator.
7. NOTE:
-
Do not reuse body support mounting fasteners. New fasteners must be installed for each fastener that has been removed or loosened.
-
No lubricants of any kind are to be used during body insulator installation.
To install, reverse the removal procedure.
Body Support - Rear, Crew Cab, Lower
BODY SUPPORT-REAR, CREW CAB, LOWER
Removal and Installation
1. Remove the rear door scuff plate.
2. Remove the rear seat.
3. If equipped, remove the utility tray from behind the rear seat.
4. Pull the carpet or mat back to expose the lower body insulator bolt head.