F 450 2WD Super Duty V10-6.8L VIN V (2005)
5. Tighten the RH rear bleeder screw and install the bleeder screw cap.
6. Repeat Steps 2, 3, 4 and 5 for the LH rear, RH front, and LH front bleeder screws in this order.
Pressure Bleeding Method
1. Clean all dirt from and remove the brake master cylinder filler cap and fill the brake master cylinder reservoir with specified brake fluid.
2. NOTE: Master cylinder pressure bleeder adapter tools are available from various manufacturers of pressure bleeding equipment. Follow the
instructions of the manufacturer when installing the adapter.
Install the bleeder adapter to the brake master cylinder reservoir, and attach the bleeder tank hose to the fitting on the adapter.
3. NOTE: Bleed the longest line first. Make sure the bleeder tank contains enough specified brake fluid to complete the bleeding operation.
Remove the bleeder screw cap and place a box end wrench on the RH rear bleeder screw. Attach a rubber drain tube to the RH rear bleeder screw,
and submerge the free end of the tube in a container partially filled with specified brake fluid.
4. Open the valve on the bleeder tank.