F 450 2WD Super Duty V10-6.8L VIN V (2005)
Power Steering Line/Hose: Service and Repair
Power Steering Pump to Hydraulic Booster Pressure Line
Power Steering Pump to Hydraulic Booster Pressure Line
Special Tool(s)
Material
Removal and Installation
CAUTION: While repairing the power steering system, care should be taken to prevent the entry of contaminants or premature failure of the power
steering components can result.
NOTE: New Teflon seals must be installed any time the power steering line fittings are disconnected.
1. Using a suitable suction device, drain the power steering fluid reservoir.
2. NOTE: Thoroughly clean all debris from the threads.
Disconnect the pressure line-to-booster fitting.
^
Discard the Teflon seal.
3. With the vehicle in NEUTRAL, position it on a hoist.
4. Remove the lower power steering pump bolt.