F 450 2WD Super Duty V10-6.8L VIN V (2005)
Crankshaft Position Sensor: Service and Repair
CRANKSHAFT POSITION (CKP) SENSOR
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery ground cable.
3. Remove the accessory drive belt.
4. Disconnect the A/C compressor electrical connector.
5. Remove the 3 bolts and position the A/C compressor aside.
-
To install, tighten to 25 Nm (18 lb-ft).
6. Disconnect the CKP sensor electrical connector.
7. Remove the bolt and the CKP sensor. Discard the O-ring seal.
-
To install, tighten to 10 Nm (89 lb-in).
-
Lubricate the new O-ring seal with clean engine oil prior to installation.
8. To install, reverse the removal procedure.