F 450 2WD Super Duty V10-6.8L VIN V (2005)
NOTE
NEW PLUGS SHOULD BE INSTALLED USING A FILM COATING OF MOTORCRAFT® HIGH TEMPERATURE NICKEL ANTI-SEIZE
LUBRICANT ON THE GROUND ELECTRODE SHIELD. DO NOT COAT THE ELECTRODE STRAP. (FIGURE 7)
Porcelain Removal - Pin Slipped Out
In the unlikely event that the pin does not remove the broken porcelain, this process can be repeated.
Key elements to success are:
^
Clean and dry porcelain
^
Sufficient Loctite® 638TM Retaining Compound spread uniformly
^
Loctite(R) 638(TM) cure time and temperature
^
Preventing the threaded rod from rotating while removing the porcelain
Replacement Supplies
Replacement kit components and additional kit consumables (Loctite(R) 638TM Retaining Compound and pins) can be obtained by calling
1-800-ROTUNDA, Option 5.
Parts Block
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage And Emissions Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
OPERATION DESCRIPTION
TIME
MT080706
Claim Labor As Actual
Actual
Time
Time
DEALER CODING
CONDITION
BASIC PART NO.
CODE
12405
01
Disclaimer