F 450 2WD Super Duty V10-6.8L VIN V (2005)
1. NOTE:
-
Make sure the safety belt webbing is not twisted prior to installation.
-
Make sure to tighten bolts to specification.
To install, reverse the removal procedure.
2. Check the restraint system for correct operation.
Safety Belt Buckle - Front, 40/20/40 Seat, Driver and Passenger
SAFETY BELT BUCKLE - FRONT, 40/20/40 SEAT, DRIVER AND PASSENGER
Removal
All vehicles
1. Remove the affected seat.
Driver safety belt buckle
2. Disconnect the safety belt warning switch electrical connector.
-
Remove the pin-type retainer from the safety belt warning switch electrical connector.
All vehicles
3. NOTE: Driver side shown, passenger side similar.
Remove the safety belt buckle.
1
Remove the safety belt buckle nut.
2
Remove the safety belt buckle.