F 450 2WD Super Duty V10-6.8L VIN V (2005)
Install the safety belt retractor.
1
Position the safety belt retractor, aligning the tabs into the sheet metal.
2
Using the special tool, install the bolt.
2. Install the driver side B-pillar trim panel, the rear assist handle and front and rear door scuff plates.
3. NOTE:
-
Prior to installation, make sure the safety belt webbing is not twisted.
-
Inspect the shoulder safety belt guide cover for damage. If the shoulder safety belt guide cover is damaged or the cover does not remain closed,
install a new shoulder safety belt guide cover.
Position the driver side shoulder safety belt guide, install the nut and close the cover.
Crew Cab passenger side
4. NOTE: Prior to installation, make sure the safety belt webbing is not twisted.
Install the front passenger side safety belt anchor.
1
Position the front passenger side safety belt anchor.
2
Using the special tool, install the bolt.
Crew Cab driver side
5. NOTE: Prior to installation, make sure the safety belt webbing is not twisted.
Install the front driver side safety belt anchor.
1
Position the front driver side safety belt anchor.