F 450 2WD Super Duty V10-6.8L VIN V (2005)
Removal
NOTE: The Single Rear Wheel (SRW) wheel hub and the Dual Rear Wheels (DRW) wheel hub are different in appearance, however, the tools and
procedures are the same with one exception: the brake disc can remain attached to the DRW hub if the longer driver handle is used to remove and install
the bearing cups and seals.
NOTE: A SRW wheel hub cutaway is shown for clarity in this procedure. However, the procedure is the same for the DRW wheel hub.
1. Remove the wheel hub. For additional information, refer to Wheel Hub See: Wheel Hub/Service and Repair/Wheel Hubs and Bearings - Full
Floating Axle - Ford.
2. Position the Handle and Differential Bearing Cup Installer on the inner bearing.
3. Using the Handle and Differential Bearing Cup Installer and holding the Handle straight, drive the inner bearing, slinger and wheel hub seal out of
the wheel hub as a unit.
-
Remove and discard the bearing, slinger and wheel hub seal.