F 450 2WD Super Duty V10-6.8L VIN V (2005)
32.
Install the transmission fluid pan and bolts. Tighten the bolts in a criss-cross pattern to 15 Nm (11 lb-ft). See Figure 68.
33.
Install the intermediate shaft and turbine speed (ISS) sensor. Tighten the bolt to 9 Nm (80 lb-in). See Figure 69.
34.
CAUTION: Make sure the converter hub is fully engaged in the front pump support and gear and that it rotates freely. Do not damage the hub
seal.
CAUTION:
If the torque converter slides out, the hub seal may be damaged.
Lubricate the converter hub with clean automatic transmission fluid. See Figure 70.
35.
CAUTION: Use care when installing the torque converter to avoid damage to the front pump stator support seal.
NOTE: