F 450 2WD Super Duty V10-6.8L VIN V (2005)
Fluid Filter - A/T: Service and Repair
Transmission Fluid In-Line Filter
Transmission Fluid In-Line Filter
Material
CAUTION: The use of any other in-line transmission fluid filter other than listed will cause damage to the transmission.
NOTE: Use the following guidelines for the in-line transmission fluid filter:
-
If the transmission was overhauled and the vehicle was equipped with an in-line fluid filter, install a new in-line fluid filter.
-
If the transmission was overhauled and the vehicle was not equipped with an in-line fluid filter, install a new in-line fluid filter kit.
-
If the transmission is being installed for a non-internal repair, do not install an in-line filter or filter kit.
-
If installing a new or a Ford-authorized remanufactured transmission, install the in-line transmission fluid filter that is supplied.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the lower right side splash shield pushpin and position the shield aside.
NOTE: Trim back the tubing shield for filter installation.
3. Remove the clamp and cut a section of return line, as illustrated.