F 450 2WD Super Duty V10-6.8L VIN V (2005)
4. NOTE: Index-mark the driveshaft to the transmission flange.
Remove and discard the bolts. Disconnect the driveshaft from the transmission.
^
Using mechanic's wire, support the driveshaft.
5. Index-mark the output shaft to the slip yoke.
6. Remove the center bearing support bolts.
7. Remove the driveshaft assembly.
8. Clean grease deposits, dirt and rust from the following:
^
The driveshaft flange yoke areas.
^
All driveshaft slip yoke areas.
9. Inspect the following:
^
the drive shaft slip yoke boot for rips or holes. Install a new boot if necessary.
^
the drive shaft center bearing support for wear or rough action. If roughness or wear is evident, install a new driveshaft center bearing support.
^
the center bearing rubber insulator for evidence of hardening, cracking or deterioration. Install a new insulator if necessary.
10. NOTE: Lubricate the slip yoke spline with grease.
NOTE: Install the driveshaft with the index marks made during removal.
NOTE: Install new bolts and retainers.
To install, reverse the removal procedure.