F 450 2WD Super Duty V10-6.8L VIN V (2005)
4. Disconnect the driveshaft from the coupling shaft.
1
Remove and discard the bolts.
2
Remove the U-Joint retainers.
^
Using mechanics wire, support the driveshaft.
5. Remove the center bearing support bolts.
6. Remove the rear driveshaft assembly.
7. NOTE: Index-mark the driveshaft to transmission flange or output shaft to slip yoke.
For vehicles equipped with a circular flange, remove and discard the bolts.
8. Remove the center bearing support bolts.