F 450 2WD Super Duty V8-5.4L SOHC VIN L (2003)
3. Position the rear disc brake caliper anchor plate. Install the bolts.
-
Tighten the bolts in the sequence shown in three stages.
-
Stage 1: Tighten bolt 1 to 400 Nm (295 ft. lbs.).
-
Stage 2: Using a suitable crowfoot socket, tighten bolt 2 to 136 Nm (100 ft. lbs.).
-
Stage 3: Mark the rear disc brake caliper anchor plate and bolt
2. Tighten bolt 2 an additional 1/8 to 1/4 turn.
All vehicles
4. Install the brake pads.
Brake Caliper Support Bracket
Brake Caliper Support Bracket
Removal and Installation
1. Remove the rear disc brake caliper anchor plate.
2. Remove the hub and rotor.
3. Remove the rear brake shoes and linings.
4. Remove the adapter nuts.
5. Slide the adapter far enough to disconnect the parking brake rear cable and conduit. Remove the rear wheel disc brake adapter and rotor shield
assembly.