F 450 2WD Super Duty V8-5.4L SOHC VIN L (2003)
10. Install the ignition switch lock cylinder.
^
Position the ignition switch lock cylinder to the RUN position.
^
Insert the ignition switch lock cylinder into the steering column.
^
Make sure the ignition switch lock cylinder is fully seated and aligned in the interlocking washer before turning the key to the OFF position.
^
Make sure the ignition switch lock cylinder retaining pin is seated in the hole in the steering column.
^
Rotate the ignition switch lock cylinder through all positions to verify operation.
11. Install the lower steering column shroud.
1
Position the lower steering column shroud.
2
Install the screws.
12. Install the tilt wheel handle and shank.
13. Install the steering wheel. Do not install the driver air bag module at this time.
WARNING: TO REDUCE THE RISK OF SERIOUS PERSONAL INJURY, READ AND FOLLOW ALL WARNINGS, CAUTIONS,
NOTES, AND INSTRUCTIONS IN THE STEERING WHEEL REMOVAL AND INSTALLATION PROCEDURE.