F 450 2WD Super Duty V8-6.0L DSL Turbo VIN P (2006)
Exhaust Pressure Sensor: Service and Repair
EXHAUST PRESSURE SENSOR
Removal and Installation
1. CAUTION: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls.
Turn the ignition switch to the OFF position.
2. Disconnect the exhaust pressure (EP) sensor electrical connector.
3. NOTE: Support the EP sensor tube flange nut when removing the EP sensor.
Remove the EP sensor.
-
To install, tighten to 10 Nm (89 lb-in).
4. To install, reverse the removal procedure.