F 450 2WD Super Duty V8-6.4L DSL Turbo (2008)
3. Remove the roof opening panel motor.
-
Remove the 3 screws.
Installation
1. Connect the roof opening panel motor electrical connector.
2. NOTE: When installing the roof opening panel motor/module, align the 3 attach holes before engaging the drive gear into the roof opening panel
drive cable. Do not rotate the motor assembly after the drive gear is engaged with the roof opening panel drive cable. Otherwise, the cable can
bind.
Install the roof opening panel motor.
-
Align the attach holes, then install the 3 screws and tighten to 4 Nm (35 lb-in).
3. Connect the overhead console electrical connectors.