F 450 2WD Super Duty V8-6.4L DSL Turbo (2008)
2. Install the EP sensor and tube assembly nut.
-
Tighten to 9 Nm (80 lb-in).
3. NOTE: Use a backup wrench on the OC-EGR fitting when tightening the EP sensor and tube assembly fitting.
Tighten the EP sensor and tube assembly fitting at the OC-EGR.
-
Tighten to 20 Nm (177 lb-in).
4. Connect the EP sensor electrical connector and attach the wiring harness C-clip to the sensor body, above the hex.