F 450 2WD Super Duty V8-6.4L DSL Turbo (2008)
3. Remove the A/C clutch disc and hub.
4. Remove the A/C compressor pulley snap ring.
5. CAUTION: Do not use air tools. Damage to the A/C clutch pulley or A/C compressor may result.
Remove the A/C compressor pulley.
1
Install the special tool.
2
Using the special tool, remove the A/C compressor pulley.
6. Remove the A/C clutch field coil snap ring.
7. Remove the A/C clutch field coil electrical connector bracket screw.
8. Remove the A/C clutch field coil.
Installation
NOTE: The A/C clutch components should be reused unless obvious signs of damage are found. If excessive grooving is found, a new A/C clutch
disc and hub and a new A/C compressor pulley must be installed together. Otherwise, each component can be installed individually where needed.
1. Visually inspect the A/C clutch disc and hub, A/C compressor pulley and A/C clutch field coil for damage.
-
Inspect for physical damage, including cracked or melted components or discoloration due to excessive heat.
-
Inspect for excessive wear, including grooving in the A/C clutch disc and hub or A/C compressor pulley that is more than fingernail depth.
-
Inspect for roughness in the A/C compressor pulley bearing.
2. Clean the A/C clutch field coil and pulley mounting surfaces.
3. Install the A/C clutch field coil.
4. Install the A/C clutch field coil snap ring.
5. Install the A/C clutch field coil electrical connector bracket screw.
6. NOTE: The A/C compressor pulley is a tight fit on the A/C compressor. It must be correctly aligned during installation.
Install the A/C compressor pulley.
7. Install the A/C compressor pulley snap ring with the bevel side out.
8. Place one nominal thickness A/C clutch disc and hub spacer inside the clutch hub spline opening.
9. Install the A/C clutch disc and hub.
10. Using the special tool, install the A/C compressor clutch disc and hub bolt.
1
Hold the A/C clutch disc and hub with the special tool.
2
Tighten the bolt to 13 Nm (10 lb-ft).