F 450 2WD Super Duty V8-6.4L DSL Turbo (2008)
Ignition Switch Lock Cylinder: Service and Repair
Ignition Lock Cylinder - Non Functional
IGNITION LOCK CYLINDER - NON FUNCTIONAL
Removal and Installation
1. Remove the steering wheel.
2. Remove the 3 screws and the lower steering column shroud.
3. Remove the ignition lock cylinder.
-
Use an 1/8-inch diameter drill bit to drill out the lock cylinder retaining pin.
-
Use a 3/8-inch diameter drill bit to drill down the middle of the ignition lock cylinder key slot until the ignition lock cylinder breaks loose.
-
Remove and discard the ignition lock cylinder and drill shavings from the steering column.
4. CAUTION: Carefully note the position of the steering column lock gear, bearing and retainer prior to removal.
Remove the bearing retainer.
5. Remove the bearing and the gear.
-
Thoroughly clean all drill shavings from the steering column and inspect it for damage.
6. NOTE: Use a new ignition lock cylinder.
To install, reverse the removal procedure.
-
Verify ignition lock cylinder operation.