F 450 2WD Super Duty V8-6.4L DSL Turbo (2008)
15. Disconnect the driver air bag module electrical connector, then disconnect the horn switch electrical connector and remove the driver air bag
module.
16. Turn the steering wheel so the top of the wheel is back in the straight-ahead position (the 12 o'clock position).
17. Open and lower the glove compartment door.
18. Remove and discard the 4 passenger air bag module deployment door screws.
19. CAUTION: Do not handle the passenger air bag module by grabbing the edges of the deployment door. Failure to follow this instruction
may result in component damage and/or system failure.
Remove and discard the 4 nuts and position out the passenger air bag module from the instrument panel (I/P)
-
To install, tighten to 9 Nm (80 lb-in).