F 450 2WD Super Duty V8-6.4L DSL Turbo (2008)
-
To install, tighten to 55 Nm (41 lb-ft).
All safety belt buckles
7. NOTE:
-
When installing a new safety belt buckle assembly, make sure it is installed on the correct side. This is due to the safety belt buckles and
tongues being different sizes from the LH to the RH side.
-
Make sure the safety belt webbing is not twisted prior to installation.
To install, reverse the removal procedure.
-
Make sure the safety belt buckles are accessible to the occupant after installation.
8. Check the active restraint system for correct operation.