F 450 2WD Super Duty V8-7.3L DSL Turbo VIN F (2002)
Fog/Driving Lamp: Service and Repair
REMOVAL
1. Remove the front license plate frame, if equipped.
2. Remove the fog lamp bracket bolts.
3. Remove the fog lamp assembly.
1
Disconnect the electrical connector.
2
Remove the pin-type retainers.
3
Remove the adjustment bolt.
4
Pull outward on the retaining tabs and remove the fog lamp.
^
If necessary install a new fog lamp bulb.
INSTALLATION
1. To install, reverse the removal procedure.
2. Before starting the fog lamp assembly adjustment:
^
check the tire inflation.
^
make sure there are no other load is in the vehicle other than a half tank of fuel.
^
make sure the vehicle is on level ground.
^
make sure the fog lamps and headlamps are clean.
^
make sure the headlamps are operating and are correctly aimed.
NOTE: Horizontal aim is not required for this vehicle and is not adjustable. Consult your state vehicle inspection center for recommended
tolerance ranges for visual aiming.