F 450 4WD Super Duty V10-6.8L (2009)
Sunroof / Moonroof Track: Service and Repair
Roof Opening Panel Rear Trough Guide
Roof Opening Panel Rear Trough Guide
Removal and Installation
NOTE: The roof opening panel must be initialized when repairs are carried out on any part of the roof opening panel, including: whenever the roof
opening panel has been removed from the roof opening panel assembly, a new roof opening panel motor/module has been installed or when a new roof
opening panel assembly has been installed. For additional information, refer to Roof Opening Panel Motor Initialization See: Testing and
Inspection/Programming and Relearning.
1. Remove the roof opening panel glass. For additional information, refer to Roof Opening Panel Glass See: Sunroof / Moonroof Panel/Service and
Repair/Roof Opening Panel Glass.
2. Remove the 2 plastic trough guide retaining screws and the trough from the trough guide assembly.
-
To install, tighten to 1 Nm (9 lb-in).
3. Disconnect the trough guide rods from the lifter arm assemblies.
4. Slide the trough guide back to the slot (approximately 15 mm [0.6 in]) cut in track.
-
Carefully twist trough guide through the slot in the track to remove.
5. Inspect the trough guide assembly for damage. If damage is found, inspect the track for broken pieces and remove them.
6. To install, reverse the removal procedure.
-
Align the roof opening panel. For additional information, refer to Roof Opening Panel Alignment See: Adjustments.
-
Initialize the roof opening panel motor. For additional information, refer to Roof Opening Panel Motor Initialization See: Testing and
Inspection/Programming and Relearning.