F 450 4WD Super Duty V10-6.8L (2009)
Disassembly and Assembly
NOTE: If both seat cushions need to be disassembled, repeat steps for other side.
1. Remove the seat cushion. For additional information, refer to Seat - Rear, SuperCab See: Service and Repair/Rear Seats/Seat - Rear, SuperCab.
2. Remove the 60 percent or 40 percent seat cushion. For additional information, refer to Seat Cushion - Rear, SuperCab See: Removal and
Replacement/Seat Cushion - Rear, SuperCab.
3. Remove the screw and latch handle cover.
4. Remove the support-to-latch bolts.
1. Remove the upper support-to-latch bolt.
-
To install, tighten to 33 Nm (24 lb-ft).
2. Remove the lower support-to-latch bolt.
-
To install, tighten to 25 Nm (18 lb-ft).
5. Remove the RH latch cover.
6. Remove the latch-to-cushion frame bolt.
-
To install, tighten to 50 Nm (37 lb-ft).
7. Release the cushion trim cover J-clip.
8. Invert and remove the cushion trim cover.
9. Remove the cushion foam pad from the cushion frame.