F 450 4WD Super Duty V10-6.8L (2009)
6. Using the Crankshaft Front Oil Seal Remover, remove and discard the crankshaft front seal.
Installation
1. Lubricate the engine front cover and the crankshaft front seal inner lip with clean engine oil.
2. Using the Crankshaft Vibration Damper Installer, Front Cover Oil Seal Installer and Crankshaft Front Oil Seal Installer, install a new crankshaft
front seal.
3. NOTE: If not secured within 4 minutes, the sealant must be removed and the sealing area cleaned with silicone gasket remover and Motorcraft
metal surface prep. Follow the directions on the packaging. Allow to dry until there is no sign of wetness, or 4 minutes, whichever is longer.
Failure to follow this procedure may cause future oil leakage.
Apply silicone gasket and sealant to the Woodruff key slot in the crankshaft pulley.
4. Using the Crankshaft Vibration Damper Installer, install the crankshaft pulley.