F 450 4WD Super Duty V10-6.8L (2009)
Camshaft - RH
7. Install the balance shaft drive gear onto the LH camshaft.
8. Install both camshaft sprockets and camshaft sprocket bolts finger-tight.
9. NOTICE: Timing chain procedures must be followed exactly or damage to valves and pistons will result.
NOTICE: Prior to installation, inspect the tensioner-sealing bead for seal integrity. If cracks, tears, separation from the tensioner body or
permanent compression of the seal bead is observed, install a new tensioner or engine damage may occur.
Using a vise, compress the tensioner plunger.
10. Install the Hydraulic Chain Tensioner Retaining Clip on the tensioner to hold the plunger in during installation.
11. NOTE: There are 61 links in each timing chain.
If copper links are not visible, mark 2 links on one end and 1 link on the other end, and use as timing marks.
12. Install the timing chain guides and the 4 bolts.
-
Tighten to 10 Nm (89 lb-in).