F 450 4WD Super Duty V10-6.8L (2009)
Accelerator Pedal: Service and Repair
Accelerator Pedal - Adjustable
Accelerator Pedal - Adjustable
Removal and Installation
1. Disconnect the accelerator pedal and position sensor assembly electrical connector.
2. Disconnect the adjustable pedal motor electrical connector.
3. Disconnect the adjustable pedal motor drive cable from the brake pedal assembly.
4. Remove the 3 nuts and the accelerator pedal and position sensor assembly.
-
To install, tighten to 9 Nm (80 lb-in).