F 450 4WD Super Duty V10-6.8L (2009)
Shift Interlock Solenoid: Service and Repair
Brake Shift Interlock Actuator
Removal and Installation
1. Set the parking brake.
2. Remove the steering column shrouds.
3. Turn the ignition to the accessory position and apply the brake or actuate the Brake Shift Interlock Actuator (BSIA) override.
4. Put the selector lever into the NEUTRAL position.
5. Disconnect the BSIA electrical connector.
6. Remove the BSIA screw.
7. Gently pry the clip up and remove the BSIA.
8. NOTE: During installation, verify that the BSIA override has been activated and the slider is fully rearward. Before rotating the selector lever
from NEUTRAL into PARK, align the selector lever tab into the BSIA.
To install, reverse the removal procedure.