F 450 4WD Super Duty V10-6.8L VIN S (1999)
Drive/Propeller Shaft: Service and Repair
Front
Removal
1. Raise and support the vehicle.
2. Index mark the front driveshaft to the front axle flange and at the transfer case flange.
3. WARNING: Replace with new bolts and retainers after the third removal.
Disconnect the front driveshaft from the front axle.
1
Mark and remove the driveshaft to front axle bolts.
2
Remove the U-joint retainers.
4. WARNING: Replace with new bolts after the third removal.
Mark and remove the four front driveshaft to transfer case bolts.