F 450 4WD Super Duty V8-6.4L DSL Turbo (2008)
1. CAUTION: Make sure the screw cap is installed over test terminal A to prevent accidental shorting to ground.
Install the 2 screws and the brush and terminal holder on the generator voltage regulator.
-
Tighten to 4 Nm (35 lb-in).
2. Install the generator brush and terminal holder - voltage regulator on the generator.
1
Press the brushes in and insert a wire to hold the brushes during installation.
2
Position the generator brush and terminal holder - voltage regulator.
3
Install the 4 generator brush and terminal holder - voltage regulator screws.
-
Tighten to 3 Nm (27 lb-in).
-
Remove the wire.
3. Install the generator.