F 550 2WD Super Duty V10-6.8L VIN S (2000)
1. Using a suitable press, install the new lug bolt aligning the serrations in the wheel hub flange made by the original lug bolt.
2. On vehicles with dual rear wheels, install the new lug bolt aligning the serrations in the wheel hub flange made by the original lug bolt.
-
Place four flat washers over the outside end of the lug bolt and thread a standard lug nut with the flat side against the washers.
-
Tighten the lug nut until the lug bolt head seats against the back side of the hub flange.
3. Remove the lug nut and flat washers.
4. On vehicles with dual rear wheels, go to Step 7.
5. Install the rear wheel hub assembly.
6. Install the disc brake caliper and rotor.
7. Install the wheel and tire assembly.
8. Tower the vehicle.
