F 550 2WD Super Duty V10-6.8L VIN S (2000)
8. Correctly route the clutch hydraulic tube and attach the clutch hydraulic reservoir to the wiring tray.
9. Install the clutch master cylinder.
^
Compress and twist the clutch master cylinder. counterclockwise 45 degrees to lock it to the clutch pedal and support bracket.
10. Seat the clutch master cylinder rubber seal to the bulkhead.
11. Route the clutch master cylinder-to-slave cylinder hydraulic tube under the brake booster reservoir.
12. Connect the power distribution box to the bracket.
13. CAUTION: When installed correctly, the flat side of the clutch pedal position switch must face the tab protruding from the clutch master cylinder
, and the switch wiring connector must be in the 12 o'clock position. Incorrect installation will damage the clutch pedal position switch and cause
insufficient clutch pedal travel.
