F 550 2WD Super Duty V10-6.8L VIN Z Bi-Fuel (2001)
3. If necessary, resurface the disc brake hub and rotor. Ford recommends on-vehicle rotor machining. Follow the lathe manufacturer's instructions.
1. Remove the wheel hub grease seal.
2. Remove the inner wheel bearing.
Installation
1. Thoroughly clean and inspect the wheel bearings and the disc brake hub and rotor.
-
Use Metal Brake Parts Cleaner F6AZ-2C410-AB or equivalent.
2. Lubricate the wheel bearings.
-
Use Premium Long-Life Grease XG-l-C or XG-l-K or equivalent meeting Ford specification ESA-M1C75-B.
3. Install a new wheel hub grease seal.
1. Install the inner wheel bearing.
2. Install a new wheel hub grease seal.
4. Install the disc brake hub and rotor.
1. Position the disc brake hub and rotor.
2. Install the outer wheel bearing.
3. Install the outer wheel bearing retainer washer.
4. Install the spindle nut.