F 550 2WD Super Duty V10-6.8L VIN Z Bi-Fuel (2001)
8. Remove the support from the axle.
9. Lower the vehicle.
Rear
Lean Correction - Rear
1. NOTE: Rear side lean can be adjusted approximately 10 mm (3/8 inch) by installing shim D7TZ-5742-A on the low side. A vehicle that is low at
the rear can be raised by installing shims at both sides.
Raise and support the vehicle frame until the weight is off the rear springs but with the tires still touching the floor.
2. Support the axle.
3. Remove and discard the four nuts and two U-bolts to allow the rear axle to separate from the rear spring.
4. Turn the shim so the recess is facing upward.